LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Self-Diagnostics - 1.8L - XE, GXE) >> Diagnostic Tests >> DTC P1140 Intake Valve Timing Control Position Sensor >> DTC Confirmation Test

DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC confirmation test has been previously performed, always turn ignition off and wait at least 10 seconds before performing next DTC confirmation test.
  1. Turn ignition on. Select DATA MONITOR mode with CONSULT-II. Start engine. Hold engine speed at 2000 RPM for at least 15 seconds.
  2. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals