DTC Confirmation Test "B"
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition on. Select DATA MONITOR mode with scan tool. Start engine and let it idle for at least 10 seconds.
- If idle speed is more than 1000 RPM, maintain the following conditions for at least 10 seconds to keep engine speed below 1000 RPM:
A/T Models
- Transmission: except Park or Neutral.
- Brake pedal: depressed.
- Vehicle speed: zero MPH.
M/T Models
- Transmission: except Neutral (3rd or 4th gear is better to keep low engine RPM).
- Accelerator pedal: released.
- Vehicle speed: zero MPH.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, turn ignition off, wait at least 10 seconds, then go to DTC CONFIRMATION TEST "C" .