LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0335: Crankshaft Position Sensor (Pos) Circuit >> DTC Confirmation Test

DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding, ensure battery voltage is more than 10.5 volts with ignition on.
  1. Turn ignition on. Select DATA MONITOR mode with scan tool. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  2. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, go to next step.
  3. Maintain engine speed at more than 1000 RPM for at least 5 seconds. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals