Sunroof Lid Seal

Removal

1. Remove glass lid, refer to GLASS LID ASSEMBLY  in this article
2. Inspect rubber edge of glass lid.
   NOTE: If rubber edge is deformed or damaged, entire glass lid must be replaced.
3. Remove sunroof lid seal from the rubber edge of glass lid by pulling it outward.

Installation

1. Inspect and clean the ditch groove of the rubber edge for dirt or debris.
2. Stretch sunroof lid seal around glass lid and push the tongue edge into the ditch groove.
   NOTE: If needed, very light taps with a rubber hammer can be used to press the seal into place.
3. Place glass lid into sunroof assembly and install, refer to GLASS LID ASSEMBLY  in this article.

Visually check sunroof lid seal for any damage, deterioration, or flattening.

• In the case of leakage around glass lid assembly, close glass lid assembly and pour water around it to find the damaged or gaped portion.
• If any damage is found, inspect and repair the body sealing surface, replace sunroof lid seal, or replace glass lid assembly as necessary. Refer to SUNROOF LID SEAL  or GLASS LID ASSEMBLY  procedures in this article, if replacement is necessary.