Glass Lid Assembly

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Removal

Open sunshade assembly.
Ensure glass lid assembly is closed.
Remove the screws securing glass lid assembly to the sunroof unit.
Remove the glass lid assembly.

Installation

Position glass lid assembly to sunroof unit.
Install the glass lid assembly screws. (First tighten left front bolt, then tighten right rear bolt on glass lid assembly to prevent lid from moving while tightening other bolts.)
Adjust the sunroof glass. Refer to "ADJUSTMENT ".
CAUTION: After installing the glass lid assembly, be sure to check gap adjustment to ensure there are no malfunctions.

Fig 1: Glass Lid Assembly Screws With Torque Specifications
Courtesy of NISSAN NORTH AMERICA, INC.