Diagnostic Procedure
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis check. Refer to "SELF-DIAGNOSTIC RESULT MODE ".
Is any malfunction detected by self-diagnosis?
YES: Check the malfunctioning system. Refer to "DISPLAY ITEMS LIST ".
No: GO TO 2.
- CHECK MANUAL MODE SWITCH
Check the manual mode switch circuit. Refer to "DTC P0826 MANUAL MODE SWITCH CIRCUIT ".
OK or NG
OK: GO TO 3.
NG: Repair or replace damaged parts.
- SYMPTOM CHECK
Check again. Refer to "CRUISE TEST ".
OK or NG
OK: INSPECTION END
NG: GO TO 4.
- CHECK TCM
- Check TCM input/output signals. Refer to "TCM INPUT/OUTPUT SIGNAL REFERENCE VALUES ".
- If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK: INSPECTION END
NG: Repair or replace damaged parts.