LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Engine Controls - Self-Diagnostics - 1.8L - Ca) >> Diagnostic Tests >> DTC P0510: Closed Throttle Position (TP) Switch >> DTC Confirmation Test (Overall Function Check)

DTC Confirmation Test (Overall Function Check)

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use the following test to check overall function of closed TP switch circuit. During this test, DTC may not be confirmed.

Malfunction is detected when battery voltage is sent to PCM from closed TP switch when throttle valve is opened. Possible causes are:

Start engine and warm to normal operating temperature. Using a DVOM, backprobe PCM harness connector and measure voltage between ground and terminal No. 40 (Yellow/Purple wire) at PCM harness connector. See Figure . At idle, battery voltage should exist. At 2000 RPM, about zero volts should exist. If voltage is not as specified, perform DIAGNOSTIC PROCEDURE  . If voltage is as specified, problem may be intermittent. See TESTING PROCEDURE  under SELF-DIAGNOSTIC SYSTEM.