DTC Confirmation Test "A"
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
Malfunction "A" is detected when PCM receives an excessively low or high voltage from IAT sensor. Possible causes are:
- IAT sensor circuit open or shorted.
- Defective IAT sensor.
Connect scan tool to Data Link Connector (DLC). See Figure . Turn ignition on. Using scan tool, select DATA MONITOR. Wait at least 5 seconds. If a first trip DTC is retrieved, perform DIAGNOSTIC PROCEDURE . If first trip DTC is not retrieved, go to next DTC confirmation test.