Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Remove inside mirror. Refer to "REMOVAL AND INSTALLATION ".
Partially remove the headliner (front edge). Refer to "HEADLINING ".
Remove the front wiper arms. Refer to "REMOVAL AND INSTALLATION OF FRONT WIPER ARMS, ADJUSTMENT OF WIPER ARMS STOP LOCATION "
Remove cowl top cover. Refer to "REMOVAL AND INSTALLATION ".
Apply a protective tape around the windshield glass to protect the painted surface from damage.
- Remove glass using piano wire or power cutting tool and an inflatable pump bag.
- If the windshield glass is to be reused, mark the body and the glass with mating marks.
  WARNING: When cutting the glass from the vehicle, always wear safety glasses and heavy gloves to help prevent glass splinters from entering your eyes or cutting your hands.
  CAUTION:
  - When a windshield glass is to be reused, do not use a cutting knife or power cutting tool.
  - Be careful not to scratch the glass when removing.
  - Do set or stand glass on its edge. Small chips may develop into cracks.
    
    Fig 1: Removing Windshield Glass
    Courtesy of NISSAN MOTOR CO., U.S.A.