Consult-II Diagnostic Test Mode Function
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-II DIAGNOSTIC TEST MODE FUNCTION TABLE
| CONSULT-II DIAGNOSTIC TEST MODE | Description |
|---|---|
| C/U INITIALIZATION | When replacing any of the following components, C/U initialization and re-registration of all NATS ignition keys are necessary. [(NATS ignition key/ BCM/ ECM] |
| SELF-DIAG RESULTS | Detected items (screen terms) are as shown in the chart. Refer to "NVIS (NATS) SELF-DIAGNOSTIC RESULTS ITEM CHART ". |
NOTE:
- When any initialization is performed, all IDs previously registered will be erased and all NATS ignition keys must be registered again.
- The engine cannot be started with an unregistered key. In this case, the system will show "DIFFERENCE OF KEY" or "LOCK MODE" as a self-diagnostic result on the CONSULT-II screen.
- In rare case"CHAIN OF ECM-IMMU" might be stored as a self-diagnostic result during key registration procedure, even if the system is not malfunctioning.