Display Item List
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-II DISPLAY ITEM LIST TABLE
| CONSULT-II display | Item | Malfunction is detected when... | Reference page |
|---|---|---|---|
| CAN COMM CIRC [U1000] | CAN communication | Malfunction is detected in CAN communication. | CAN COMMUNICATION INSPECTION USING CONSULT-II (SELF-DIAGNOSIS) |
| SEAT SLIDE [B2112] | Seat slide motor | When any manual and automatic operations are not performed, if any motor operations of seat slide is detected for 0.1 second or more, status is judged "Output error". | SLIDING MOTOR CIRCUIT INSPECTION SLIDING SENSOR CIRCUIT INSPECTION |
| SEAT RECLINING [B2113] | Seat reclining motor | When any manual and automatic operations are not performed, if any motor operations of seat reclining is detected for 0.1 second or more, status is judged "Output error". | RECLINING MOTOR LH CIRCUIT INSPECTION RECLINING SENSOR CIRCUIT INSPECTION |
| SEAT LIFTER FR [B2114] | Seat lifting FR motor | When any manual and automatic operations are not performed, if any motor operations of seat lifting FR is detected for 0.1 second or more, status is judged "Output error". | LIFTING MOTOR (FRONT) CIRCUIT INSPECTION LIFTING SENSOR (FRONT) CIRCUIT INSPECTION |
| SEAT LIFTER RR [B2115] | Seat lifting RR motor | When any manual and automatic operations are not performed, if any motor operations of seat lifting RR is detected for 0.1 second or more, status is judged "Output error". | LIFTING MOTOR (REAR) CIRCUIT INSPECTION LIFTING SENSOR (REAR) CIRCUIT INSPECTION |
| ADJ PEDAL MOTOR [B2117] | Pedal adjust motor | When any manual and automatic operations are not performed, if motor operations of seat pedal is detected for 0.1 second or more, status is judged "Output error". | PEDAL ADJUSTING MOTOR CIRCUIT INSPECTION PEDAL ADJUSTING SENSOR CIRCUIT INSPECTION |
| ADJ PEDAL SENSOR [B2120] | Pedal adjust sensor | When pedal adjust sensor detects 0.5V or lower, or 4.5V or higher, for 0.5 seconds or more. | PEDAL ADJUSTING SENSOR CIRCUIT INSPECTION |
| DETENT SW [B2126] | Park SW | With the A/T shift lever in P position (Park switch OFF), if the vehicle speed of 7 km/h (4 MPH) or higher was input the park switch input system is judged malfunctioning. | A/T DEVICE (PARK SWITCH) CIRCUIT INSPECTION |
| UART COMM [B2128] | UART communication | Malfunction is detected in UART communication. | UART COMMUNICATION LINE CIRCUIT INSPECTION |
NOTE:
- If park switch error is detected, manual adjustable pedal operation cannot be performed when ignition switch turns ON.
- The displays of CAN communication and detection switch display error detecting condition from memory erase to the present on "TIME".
- If error is detected in the past and present error is detected, "CRNT" is displayed.
- If error is detected in the past and present error is not detected, "PAST" is displayed.
- If error has never been detected, nothing is displayed on "TIME".
- Any items other than CAN communication and park switch count error detection frequency occurred after erase history to "1-127".
- If error was detected in the past, error detection frequency from memory erase to the present is displayed on "TIME".
- If error has never been detected, nothing is displayed on "TIME".
- Can clear the detected memory.
Normal: Clear memory in normal condition, history is erased and nothing is displayed on "TIME".
Error: Clear memory in error condition, error is detected again and "1" is displayed on "TIME".