Removal and Installation: Removal
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery terminal.
- Remove the cowl top extension. Refer to "REMOVAL AND INSTALLATION - COWL TOP EXTENSION ".
- Drain the brake fluid. Refer to "CHANGING BRAKE FLUID ".
- Disconnect the actuator harness from the ABS actuator and electric unit (control unit).CAUTION:
- To remove the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged.
- Be careful not to splash brake fluid on painted areas.
- Disconnect the brake tubes.
- Remove the two bolts and then the ABS actuator and electric unit (control unit).