LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1503 (Wiper, Washer & Horn) >> Front Wiper And Washer System >> Removal and Installation of Wiper Motor and Linkage >> Installation

Removal and Installation of Wiper Motor and Linkage: Installation

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not drop the wiper motor or cause it to contact other parts.
  • Check the grease conditions of the motor arm and wiper link joint(s). Apply grease if necessary.
  1. Connect wiper motor to connector. Turn the wiper switch ON to operate wiper motor, then turn the wiper switch OFF (auto stop).
  2. Disconnect wiper motor connector.
  3. Install wiper motor to wiper frame assembly, and install assembly into the vehicle.
  4. Connect wiper motor connector. Turn the wiper switch ON to operate the wiper motor, then turn wiper switch OFF (auto stop).
  5. Install cowl top extension. Refer to REMOVAL AND INSTALLATION - COWL TOP EXTENSION .
  6. Install wiper arms. Refer to REMOVAL AND INSTALLATION OF FRONT WIPER ARMS, ADJUSTMENT OF WIPER ARMS STOP LOCATION .
scientia non olet · About LEMON Manuals