LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Engine Controls Self-Diagnostics - Pathfinder) >> Diagnostic Tests >> DTC P1706: Park/Neutral Position Switch - Circuit Malfunction >> DTC Confirmation Test (Using CONSULT-II)

DTC Confirmation Test (Using CONSULT-II)

WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing.
  1. Turn ignition on. Select P/N POSI SW in DATA MONITOR mode with CONSULT-II.
  2. Check P/N POSI SW signal under the following conditions.
    • With transmission in Park or Neutral, ON should be displayed.
    • With transmission in other position except Park or Neutral, OFF should be displayed.

    If operation is as specified, go to next step. If operation is not as specified, go to DIAGNOSTIC PROCEDURE .

  3. Select DATA MONITOR mode with CONSULT-II. Start engine and warm to normal operating temperature.
  4. Maintain following conditions for at least 60 consecutive seconds:
    • ENG SPEED: 1500-2500 RPM
    • COOLAN TEMP/S: more than 158°F (70°C)
    • B/FUEL SCHDL: 3.6-12 msec
    • VHCL SPEED SE: 43 MPH or more
    • Transmission selector lever: Any forward gear

    If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.

scientia non olet · About LEMON Manuals