DTC Confirmation Test
WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition on.
- Select "DATA MONITOR" mode with CONSULT-II.
- Maintain the following conditions for at least 10 consecutive seconds:
- ENGSPEED: 1200-2000 RPM.
- COOLANT TEMPS: More than 140°F (60°C).
- Selector lever: 1st position.
- Driving location: Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test).
- Maintain the following conditions for at least 10 consecutive seconds:
- ENGSPEED: Idle.
- COOLANT TEMPS: More than 140°F (60°C).
- Selector lever: PARK or NEUTRAL position.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .