DTC Confirmation Procedure "A"

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform DTC confirmation test "A" first. If 1st trip DTC cannot be confirmed, turn ignition OFF and wait at least 10 seconds before performing next DTC confirmation test.

NOTE: If engine will not start or stops soon, wait at least 10 seconds with engine stopped (Ignition switch ON) instead of running engine at idle speed.

Using CONSULT-II & GST

Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.
Start engine and warm to operating temperature.
Run engine for at least 10 seconds at idle speed.
If DTC is detected, see DIAGNOSTIC PROCEDURE .