LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2024 >> Eclipse Cross SEL >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> MITSUBISHI Connect Safeguard Services & Remote Services >> Data List Reference Table

Data List Reference Table

The following items can be read by the scan tool (M.U.T.-IIISE) from the TCU input data.

DATA LIST REFERENCE

Item No. Scan tool (M.U.T.-IIISE) display Check condition Normal condition
1 Switch status
  • Ignition switch: ON
  • SOS switch and Information switch: OFF
No switch press
  • Ignition switch: ON
  • SOS switch and Information switch: ON
All switch pressed
  • Ignition switch: ON
  • SOS switch: ON
  • Information switch: OFF
e-Call switch pressed
  • Ignition switch: ON
  • SOS switch: OFF
  • Information switch: ON
b-Call switch pressed
2 Telephone antenna field intensity
  • Ignition switch: ON
NOTE: Park the vehicle in an open area where radio wave is not shielded.
-106.7 dBm or more
3 Number of GPS/GLONASS satellite
  • Ignition switch: ON
NOTE: Park the vehicle in an open area where radio wave is not shielded.
4 pieces or more
4 Speaker's switching status ECALL speaker: In operation Emergency speaker
Front door speaker (RH): In operation Door speaker
5 Battery voltage Always Battery positive voltage
6 Ignition voltage Ignition switch: ON Battery positive voltage
7 Remote engine start: Operating time If using your mobile App to activate remote climate controls 10 minutes
Mobile App non-operation Not setup
8 Remote A/C: Heated Windscreen request If asking for activating the heated windshield from your mobile App in the vehicle equipped with the heated windshield ON
When the either one of the following conditions is satisfied;
  • If asking for halting the heated windshield from your mobile App in the vehicle equipped with the heated windshield
  • Your mobile App is not used in the vehicle equipped with the heated windshield
  • For the vehicle not equipped with the heated windshield
OFF
9 Remote A/C: A/C ON request When the either one of the following conditions is satisfied;
  • If asking for halting the air conditioning from your mobile App
  • Mobile App non-operation
OFF
When request operation for A/C activation by mobile App ON
10 Remote A/C: A/C auto mode request When the either one of the following conditions is satisfied;
  • If asking for halting the auto A/C from your mobile App
  • Mobile App non-operation
OFF
When request operation for auto A/C activation by mobile App ON
11 Remote A/C: Dual A/C auto mode request Always OFF
12 Remote A/C: Left temperature request Mobile App non-operation 0
If asking for setting the A/C temperature from your mobile App Level settings, 1-29, are displayed.
Lower level setting:
Lower temperatures
Higher level setting:
Higher temperatures
NOTE: Temperature display might be different from actual temperatures.
13 Remote A/C: Right temperature request Mobile App non-operation 0
If asking for setting the A/C temperature from your mobile App Level settings, 1-29, are displayed.
Lower level setting:
Lower temperatures
Higher level setting:
Higher temperatures
NOTE: Temperature display might be different from actual temperatures.
14 Remote A/C: A/C mode request Mobile App non-operation FACE
If asking for switching the A/C mode from your mobile App Depending on setting of mode, one of the following modes is displayed.
  • DEF
  • AUTO
15 Remote A/C: Rear defogger request When the either one of the following conditions is satisfied;
  • If asking for halting the rear window defogger from your mobile App
  • Mobile App non-operation
OFF
When request operation for rear window defogger by mobile App ON
16 Remote A/C: A/C fan request Mobile App non-operation OFF
If asking for switching the A/C fan speed from your mobile App Depending on setting of mode, one of the following modes is displayed.
  • AUTO
  • Speed 1 - 8
17 Remote A/C: Out/inside air selection damper request Mobile App non-operation -
If asking for switching between the recirculating and fresh air modes from your mobile App Depending on setting of mode, one of the following modes is displayed.
  • Fresh
  • AUTO
18 Remote A/C: Heated Windscreen (A/C ECU) When the either one of the following conditions is satisfied;
  • If the heated windshield is turned off in the vehicle equipped with the heated windshield
  • For the vehicle not equipped with a heated windshield
OFF
Automobile heated windshield: ON ON
19 Remote A/C: A/C ON (A/C ECU) Automobile A/C: OFF OFF
Automobile A/C: ON ON
20 Remote A/C: A/C auto mode (A/C ECU) Automobile auto A/C: OFF OFF
Automobile auto A/C: ON ON
21 Remote A/C: Dual A/C auto mode (A/C ECU) Automobile dual auto A/C: OFF OFF
Automobile dual auto A/C: ON ON
22 Remote A/C: Left temperature (A/C ECU) The temperature setting for air conditioning at the driver's seat is displayed. Level settings, 1-29, are displayed.
Lower level setting:
Lower temperatures
Higher level setting:
Higher temperatures
NOTE: Temperature display might be different from actual temperatures.
23 Remote A/C: Right temperature (A/C ECU) The temperature setting for air conditioning at the driver's seat is displayed. Level settings, 1-29, are displayed.
Lower level setting:
Lower temperatures
Higher level setting:
Higher temperatures
NOTE: Temperature display might be different from actual temperatures.
24 Remote A/C: A/C mode (A/C ECU) The air flow direction is displayed. Depending on setting of mode, one of the following modes is displayed.
  • FACE
  • FACE/FOOT
  • FOOT
  • DEF/FOOT
  • DEF
  • AUTO
25 Remote A/C: Rear defogger (A/C ECU) Automobile rear window defogger: OFF OFF
Automobile rear window defogger: ON ON
26 Remote A/C: A/C fan (A/C ECU) The air flow volume settings are displayed. Depending on setting of mode, one of the following modes is displayed.
  • OFF
  • AUTO
  • Speed 1 - 8
27 Remote A/C: Out/inside air selection damper (A/C ECU) The recirculating and fresh air modes are displayed. Depending on setting of mode, one of the following modes is displayed.
  • Fresh
  • Recirculation
  • AUTO
28 Backup battery lifetime When all of the following conditions are satisfied
  • Ignition switch: ON
  • The expiration date indicated on the label of the TCU battery has not been passed.
  • The TCU battery power is remained.
NOTE: Regardless of the expiration date of TCU battery, TCU battery runs out due to emergency call, and displays NG.
OK
When the Ignition switch is ON, when one of the following conditions is satisfied
  • The expiration date stated on the label of the TCU battery has been passed.
  • The TCU battery power is not remained.
NG
29 Backup battery voltage Ignition switch: ON Battery positive voltage
30 Audio amplifier judgement Without audio amplifier Not present
With audio amplifier Present
31 Speaker volume Default Medium
32 Transport mode Not used