Head Up Display (HUD)
- Special Tools
- Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Trouble in HUD power supply system [Communication with the scan tool (M.U.T.-IIISE) is not possible.]
- Inspection Procedure 2: The combiner does not work, open or close normally even if combiner open/close switch is operated
- Inspection Procedure 3: The position of the combiner display area cannot be adjusted even if the angle adjustment switch is operated
- Inspection Procedure 4: The position of the combiner display area cannot be adjusted even if the angle adjustment switch is operated
- Inspection Procedure 5: Nothing is displayed in the combiner display area (HUD can be activated) Inspection Procedure 6: Part of information is not displayed correctly in the combiner display area (HUD can be activated.)
- Inspection Procedure 7: Auto light control function does not work
- Inspection Procedure 8: Brightness decreases
- Data List Reference Table
- Special Function Table
- Inspection By Warning Screen
- Check At Ecu Terminal
- HUD
- HUD Switch