Locating the BSW reflector
CAUTION:
To carry out an accurate inspection, keep away any metal obstacles other than a bench (e.g. garage jack) where the reflector is placed from the reflector as shown below.
To carry out an accurate inspection, keep away any metal obstacles other than a bench (e.g. garage jack) where the reflector is placed from the reflector as shown below.
- Draw line (a) from the center of the Three-diamond mark on the front and rear ends (line a: vehicle center line).
- Draw line (b) from the center of the Three-diamond mark on the rear wheel (line b: rear axle center line).
- The bottom of the reflector should be positioned 2, 084 ± 30 mm (82 ± 1.2 in) from the vehicle center line and 2, 106 ± 30 mm (82.9 ± 1.2 in) from the rear axle center line. <Up to 20 Model year>
- The bottom of the reflector should be positioned 2, 020 ± 30 mm (79.5 ± 1.2 in) from the vehicle center line and 2, 228 ± 30 mm (87.7 ± 1.2 in) from the rear axle center line. <From 22 Model year>
- The top of reflector should be 765 ± 20 mm (30.1 ± 0.8 in) away from the floor and the bottom should be parallel to the BSW-ECU as shown above. <Up to 20 Model year>
- The top of reflector should be 800 ± 20 mm (31.5 ± 0.8 in) away from the floor and the bottom should be parallel to the BSW-ECU as shown above. <From 22 Model year>NOTE: Ensure that the tire pressures are correct and the vehicle is parked on a flat level at curbside weight.