Check process

Required Special Tools: 

• MB992744: Vehicle communication interface-Lite (V.C.I.-Lite)
• MB992745: V.C.I.-Lite main harness A
• MB992747: V.C.I.-Lite USB cable short
• MB992748: V.C.I.-Lite USB cable long

1. Connect the scan tool (M.U.T.-IIISE).
2. Ensure that the BSW system is turned on. If no, operate the blind spot warning switch to turn on the system.
3. Proceed to the steps below on the scan tool (M.U.T.-IIISE):
   1. Select "BSW" or "BSW (SUB)."
      NOTE: Select "BSW" for the BSW-ECU (master) and "BSW (SUB)" for the BSW-ECU (slave), respectively.
   2. Select "Special function."
   3. Select "Test."
   4. Select "Radar detecting angle check."
4. Observe the flow chart below:

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.