LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (2.0L Engine Non-Turbo) - Lancer) >> On-Vehicle Service >> Drive Belt Tension Check

Drive Belt Tension Check

WARNING: This page is about a different variant/trim than selected.
  1. Remove the radiator condenser tank mounting bolt, and move the radiator condenser tank to a place where it does not interfere with the drive belt tension check (Refer to RADIATOR ).
    CAUTION: Check the drive belt tension after turning the crankshaft clockwise one turn or more.
  2. Make sure that the indicator mark on the drive belt auto-tensioner is within the area marked with A in the illustration.
  3. If the mark is out of the area A, replace the drive belt (Refer to << B >> DRIVE BELT REMOVAL  ).
    NOTE: The drive belt tension adjustment is not necessary as the auto-tensioner is adopted.
  4. Install the radiator condenser tank to the original position (Refer to RADIATOR ).
    Fig 1: Checking Drive Belt Tension
    G09618932Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals