<< B >> Drive Belt Removal
WARNING: This page is about a different variant/trim than selected.
To introduce the serpentine drive system with the auto-tensioner, the following operations will be required.
WARNING:
Be sure to set the tool to the hexagonal part securely to prevent the tool from falling off because the tension of the auto-tensioner is high.
- Securely set the tool to the hexagonal part of the auto-tensioner.
- Rotate the auto-tensioner anti-clockwise.
- Insert the L-shaped hexagon wrench into the auto-tensioner hole to fix the auto-tensioner.CAUTION: To reuse the drive belt, draw an arrow indicating the rotating direction on the back of the belt using chalk to install the same direction.
- Remove the drive belt.