LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Twin Clutch-SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (5 Of 6)) >> Diagnosis < Shift Lever > >> Diagnostic Trouble Code Procedures >> DTC U0101: TC-SST Time-out Error >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Scan tool CAN bus diagnostics 

    Using the scan tool, diagnose the CAN bus lines.

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Repair the CAN bus lines. (Refer to TROUBLESHOOTING .) After repairing the CAN bus line, go to Step 2.
  2. STEP 2. Scan tool diagnostic trouble code 

    Check the TC-SST diagnostic trouble code. (Refer to DIAGNOSTIC TROUBLE CODE TABLE .)

    Q: Is the DTC set? 

    1. YES:  Perform the relevant troubleshooting.
    2. NO:  Go to Step 3.
  3. STEP 3. Check whether the DTC is reset. 

    Q: Is DTC No. U0101 set? 

    1. YES:  Replace the shift lever assembly. (Refer to >> A << TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE/SHIFT LEVER SIDE) INSTALLATION .)
    2. NO:  Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
scientia non olet · About LEMON Manuals