Special Tools
WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
| MB992080 Belt tension meter set
|
Tool not available | Drive belt tension (frequency) measurement | |
| MB991958 Scan tool (M.U.T.-III sub assembly)
|
MB991824-KIT
NOTE:
MB991826 M.U.T.-III Trigger Harness is not necessary when pushing V.C.I. ENTER key.
|
CAUTION:
For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.
|
|
| MB992278 Belt tension release wrench |
- | Auto-tensioner tension release | |
| MB990767 Front hub and flange yoke holder |
MB990767-01 | Holding the crankshaft pulley | |
| MD998719 Pin |
MIT308239 | ||
| MB992103 Chain tension release bar |
- | Camshaft and camshaft sprocket assembly (exhaust side) removal | |
| MD998772 Valve spring compressor |
General service tool | Valve spring compression | |
| MB992090 Retainer holder attachment |
- | ||
| MB992089 Retainer holder C |
- | ||
| MB992085 Valve stem seal pliers |
- | Valve stem seal removal | |
| MD998737 Valve stem seal installer |
MD998737-01 | Valve stem seal press-fitting | |
| MD998727 Oil pan FIPG cutter |
MD998727-01 | Engine oil pan removal | |
| MB991883 Flywheel stopper |
General service tool | Supporting the flywheel | |
| MB991448 Bush remover and installer base |
MB991448-01 | Press-fitting the crankshaft front oil seal | |
| MB991928 Engine hanger
|
Tool not available | Supporting the engine assembly
NOTE:
Special tool MB991454 is a part of engine hanger attachment set MB991453.
|
|
| MB991895 Engine hanger |
Tool not available | ||
| MB991454 Engine hanger balancer |
MZ203827-01 |