LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Mechanical (2.0L Engine Turbo) - Lancer) >> On-Vehicle Service >> Drive Belt Tension Check

Drive Belt Tension Check

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the radiator condenser tank, and move the radiator condenser tank to a place where it does not interfere with the drive belt tension check.
    CAUTION: Check the drive belt tension after turning the crankshaft clockwise one turn or more.
  2. Make sure that the indicator mark on the auto-tensioner is within the area marked with A in the illustration.
  3. If the mark is out of the area A, replace the drive belt (Refer to << A >> DRIVE BELT REMOVAL  .)
    NOTE: The drive belt tension adjustment is not necessary as the auto-tensioner is adopted.
  4. Install the radiator condenser tank to the original position.
    Fig 1: Identifying Auto-Tensioner Indicator Mark Area
    G05374013Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals