LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Mechanical (2.0L Engine Turbo) - Lancer) >> Engine Assembly >> Removal And Installation >> Removal Service Points >> << C >> Engine Mounting Bracket/Engine Assembly Removal

<< C >> Engine Mounting Bracket/Engine Assembly Removal

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When supporting the engine assembly with a garage jack, be careful not to deform the engine oil pan.
  1. Place a garage jack against the engine oil pan with a piece of wood in between to support the engine assembly.
  2. Remove special tool MB991928 or MB991895 which was installed for supporting the engine assembly when the transaxle assembly was removed (Refer to TRANSAXLE ASSEMBLY .)
    Fig 1: Identifying Special Tool MB991928
    G05375588Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Special Tool MB991454
    G05902062Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Set special tool MB991454 to the engine hanger and the power steering oil pump bracket.
    Fig 3: Mounting Special Tool MB991454 To Power Steering Oil Pump Bracket And Engine Hanger
    G05392462Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Hold the engine assembly with a chain block.
  5. Place a garage jack against the engine oil pan with a piece of wood in between, and remove the engine mounting bracket while adjusting the position of the engine.
  6. After checking that all cables, hoses and wiring harness connectors and so on are disconnected from the engine, raise the vehicle slowly with a lift, and remove the engine assembly downwards from the engine compartment.
    Fig 4: Holding Engine Assembly Using Chain Block
    G05392483Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals