LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Mechanical (2.0L Engine Turbo) - Lancer) >> Engine Assembly >> Removal And Installation >> Installation Service Points >> >> A << Engine Assembly/Engine Mounting Bracket Installation

>> A << Engine Assembly/Engine Mounting Bracket Installation

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the engine assembly below the lifted vehicle.
  2. Install the engine assembly, being careful not to pinch the cables, hoses, or wiring harness connectors.
  3. Set special tool MB991454 and a chain block to the engine assembly.
    CAUTION: When supporting the engine assembly with a garage jack, be careful not to deform the engine oil pan.
  4. Place a garage jack against the engine oil pan with a piece of wood in between, and install the engine mounting bracket while adjusting the position of the engine.
  5. Remove the chain block.
    Fig 1: Mounting Special Tool MB991454 To Power Steering Oil Pump Bracket And Engine Hanger
    G05392462Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Holding Engine Assembly Using Chain Block
    G05392483Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Install special tool MB991928 or MB991895 which is used during installation of transaxle assembly to hold the engine assembly (Refer to TRANSFER ASSEMBLY .)
  7. Remove the garage jack.
    Fig 3: Identifying Special Tool MB991928
    G05375588Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 4: Identifying Special Tool MB991454
    G05902062Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals