Drive Belt (For The Generator And Power Steering Oil Pump): Replace

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the radiator condenser tank mounting bolts.
Move the radiator condenser tank to a place where it will not be a hindrance when checking the drive belt tension.
CAUTION: Check the drive belt tension after turning the crankshaft clockwise one turn or more.
Make sure that the indicator mark on the auto-tensioner is within the area marked with A in the illustration.
If the mark is out of the area A, replace the drive belt. (Refer to CRANKSHAFT PULLEY ).
NOTE: The drive belt tension check is not necessary as the auto-tensioner is adopted.

Fig 1: Identifying Indicator Mark On Auto-Tensioner
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Tighten the radiator condenser tank mounting bolts to the specified torque.
Tightening torque: 12 ± 2 N.m (102 ± 22 in-lb)