Diagnostic Trouble Code Chart
CAUTION:
- During troubleshooting, a DTC associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTCs. If DTCs are stored, erase them all.
- If the combination meter needs to be replaced as a result of troubleshooting, the current driving distance and elapsed days must be entered into the meter after the replacement in order to be used for service reminder function. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current schedule" from the meter before the replacement using the special function of scan tool (M.U.T.-III), and note them. For the operation method of scan tool (M.U.T.-III), refer to HOW TO SET BY OPERATING THE SCAN TOOL (M.U.T.-III)
. If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read from the meter using scan tool (M.U.T.-III), use the following method.
- For the driving distance for check warning, use the driving distance displayed on the multi information display.
- For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service reminder function start date) and current date.
| DTC No. | Diagnostic item |
|---|---|
| B1200 | Odometer failure |
| B1201 | Fuel information problem |
| B1209 | Test mode |
| B2463 | Rheostat switch sticking |
| B2464 | Meter information SW sticking < High contrast meter > |
| U0100 | Engine CAN timeout |
| U0141 | ETACS CAN timeout |
| U0164 | A/C CAN timeout |
| U0168 | WCM/F.A.S.T. CAN timeout |
| U0184 | AUDIO CAN timeout |
| U0230 | Power Gate CAN timeout |
| U0245 | NAVI/DISP.AUDIO CAN timeout |
| U1000 | OSS CAN timeout |
| U1190 | No receive fault detect signal |
| U1195 | Coding not completed |