INSPECTION PROCEDURE 2: Difficult Steering Wheel Operation (Insufficient Power Assist): Diagnosis

STEP 1. Check the power steering oil pump drive belt tension.
Refer to DRIVE BELT TENSION CHECK < 2.0L Engine >, and DRIVE BELT TENSION CHECK < 2.4L Engine >.

Q: Is the power steering oil pump drive belt tension within the standard value?
- YES: Go to Step 2.
- NO: Adjust the tension (Refer to DRIVE BELT TENSION CHECK < 2.0L Engine >, and DRIVE BELT TENSION CHECK < 2.4L Engine >). Then go to Step 10.
STEP 2. Check the drive belt for damage.
Q: Is the drive belt damaged?
- YES: Replace the drive belt (Refer to DRIVE BELT TENSION CHECK < 2.0L Engine >, and DRIVE BELT TENSION CHECK < 2.4L Engine >). Then go to Step 10.
- NO: Go to Step 3.
STEP 3. Check the fluid level.
1. Park the vehicle on a flat, level surface, and then start the engine.
2. Turn the steering wheel several times to raise the temperature of the fluid to approximately 50 - 60°C (122 - 140°F).
3. With the engine running, turn the wheel all the way to the left and right several times.
4. Check the fluid in the oil reservoir for foaming or milkiness. Check the difference of the fluid level when the engine is stopped, and while it is running. If the change of the fluid level is 5 mm (0.2 inch) or more, bleed the air from the system (Refer to POWER STEERING SYSTEM AIR BLEEDING ).
Q: Is the fluid foamy?
- YES: Go to Step 4.
- NO: Go to Step 10.
  
  Fig 1: Checking Fluid In Oil Reservoir For Foaming/Milkiness
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 4. Check for entry of air.
Q: Has air entered?
- YES: Bleed the air (Refer to POWER STEERING SYSTEM AIR BLEEDING ). Then go to Step 10.
- NO: Go to Step 5.
STEP 5. Check each hose for crushing or twisting.
Q: Is any hose crushed or twisted?
- YES: Repair or replace the hose (Refer to POWER STEERING HOSES ). Then go to Step 10.
- NO: Go to Step 6.
STEP 6. Check for oil leaks.
Q: Are there oil leaks?
- YES: Repair it. Then go to Step 10.
- NO: Go to Step 7.
STEP 7. Check the wheel alignment (camber and caster).
Refer to FRONT WHEEL ALIGNMENT CHECK AND ADJUSTMENT .

Q: Is the alignment incorrect?
- YES: Adjust it (Refer to FRONT WHEEL ALIGNMENT CHECK AND ADJUSTMENT ). Then go to Step 10.
- NO: Go to Step 8.
STEP 8. Check the gear box rack piston seal for damage.
Q: Is there damage?
- YES: Replace it (Refer to DISASSEMBLY AND ASSEMBLY ). Then go to Step 10.
- NO: Go to Step 9.
STEP 9. Check for excessive tie rod end ball joint breakaway torque.
Refer to BALL JOINT DUST COVER CHECK .

Q: Is there fault?
- YES: Replace the part (Refer to DISASSEMBLY AND ASSEMBLY ). Then go to Step 10.
- NO: Go to Step 10.
STEP 10. Check the steering wheel operation.
Verify that the steering wheel operation is not difficult.

Q: Is the steering wheel operation difficult?
- YES: Repeat from Step 1.
- NO: The procedure is complete.