LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L Turbo - Lancer) >> On-Vehicle Service >> Drive Belt Tension Check

Drive Belt Tension Check

WARNING: This page is about a different variant/trim than selected.
  1. Remove the radiator condenser tank, and move the radiator condenser tank to a place where it does not interfere with the drive belt tension check.
    CAUTION: Check the drive belt tension after turning the crankshaft clockwise one turn or more.
  2. Make sure that the indicator mark on the auto-tensioner is within the area marked with A in the illustration.
  3. If the mark is out of the area A, replace the drive belt (Refer to << A >> DRIVE BELT REMOVAL  .)
    NOTE: The drive belt tension adjustment is not necessary as the auto-tensioner is adopted.
  4. Install the radiator condenser tank to the original position.
    Fig 1: Identifying Auto-Tensioner Indicator Mark Area
    G05374013Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals