LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Maintenance >> Schedule >> General Information - Lancer >> Maintenance Service (2.0L Engine Turbo) >> 13. Transfer Oil (With Active Center Differential) >> Check Oil Level

Check Oil Level

  1. Remove the engine room under cover front B assembly. (Refer to REMOVAL AND INSTALLATION .)
  2. Remove the filler plug and gasket.
    Fig 1: Identifying Oil Drain Plug And Oil Filler Plug
    G05392273Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Check that the oil level is not 14 mm (0.6 inch) below the bottom of the oil filler plug hole.
  4. Check that the oil is not excessively foul and has moderate viscosity.
  5. If the oil level is not in between the upper limit and the lower limit, refill the specified oil to the bottom of the oil filler plug hole.

    Brand name: Mitsubishi Motors Genuine LSD gear oil 

  6. Install the filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  7. Install the engine room under cover front B assembly. (Refer to REMOVAL AND INSTALLATION .)
    Fig 2: Identifying Filler Plug, Hole And Gasket
    G07028303Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals