Diagnostic Trouble Code Table
CAUTION:
During diagnosis, a DTC code associated with another system may be set when the ignition switch is turned on with connector(s) disconnected. After completing the repair, confirm all systems for DTC code(s). If DTC code(s) are set, erase them all.
DIAGNOSTIC TROUBLE CODE TABLE
| Diagnostic trouble code No. | Diagnostic item | Reference |
|---|---|---|
| B10C0 | Interior temperature sensor system (short circuit) | B10C0 ; B10C1 |
| B10C1 | Interior temperature sensor system (open circuit) | |
| B1000 | Control panel communication error | Refer to DIAGNOSTIC TROUBLE CODE CHART |
| B1003 | Mode dial SW error | |
| B1018 | Temperature control dial SW error | |
| B1021 | Fan dial SW error | |
| B1031 | Air thermo sensor system (short circuit) | |
| B1032 | Air thermo sensor system (open circuit) | |
| B1034* | Ambient air temperature sensor system (short circuit) | |
| B1035* | Ambient air temperature sensor system (open circuit) | |
| B1079 | Refrigerant leaks | |
| B2214 | Control panel failure | |
| U1415 | Coding not completed | |
| U0019 | Bus off (CAN1) | |
| U0141 | ETACS-ECU time-out | |
| U0151 | SRS-ECU time-out | |
| U0154 | Occupant classification-ECU time-out | |
| U0155 | Combination meter time-out | |
| U0168 | WCM time-out | |
| U0184 | Audio time-out | |
| U0195 | Satellite radio tuner time-out | |
| U0197 | Hands free module time-out | |
|
NOTE:
The diagnostic trouble codes marked by * are set from the ETACS-ECU.
|
||