LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (6 Of 6)) >> On-Vehicle Service >> Transfer Oil Check

Transfer Oil Check

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine room under cover front B assembly. (Refer to REMOVAL AND INSTALLATION .)
  2. Remove the filler plug and gasket.
    Fig 1: Identifying Engine Oil Pan, Filler And Drain Plug
    G06676886Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Check that the oil level is not 14 mm (0.6 inch) below the bottom of the oil filler plug hole.
  4. Check that the oil is not excessively foul and has moderate viscosity.
  5. If the oil level is not in between the upper limit and the lower limit, refill the specified oil to the bottom of the oil filler plug hole.

    Brand name: Mitsubishi Motors Genuine LSD gear oil 

    Fig 2: Identifying Transfer Oil Level
    G07028303Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Install the filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  7. Install the engine room under cover front B assembly. (Refer to REMOVAL AND INSTALLATION .)
scientia non olet · About LEMON Manuals