Teach-In Reference Table
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Be careful with the following items when performing Item No. 3: Line Pressure Test.
- The engine speed could be high (4, 000 r/min) when the Line Pressure Test is in progress. (Depending on the transaxle state, the engine speed may not be high.)
- After Teach-In completion, check that it completed normally. (Teach-In execution results is displayed in the following Data list.)
TEACH-IN DESCRIPTION
| Item No. | Scan tool Item Name |
|---|---|
| 1 | Plausibility check |
| 2 | Shift fork Teach-In |
| 3 | Line pressure Test |
| 4 | Stroke Teach-In |
| 5 | Boost Teach-In |
| 6 | Interlock Teach-In |
| 7 | Clutch Ventilation |
| 8 | Reset clutch gain |
NOTE:
- According to the transmission fluid state (fluid-filled state), Teach-In executed time is not equal.
- Item No. 8 is not displayed when the Diag. Version of TC-SST-ECU is 0001. (Diag. Version can be checked by the Teach-In screen of scan tool.)
DATA LIST
| No. | Data List Item Name | Teach-In state or result | Scan tool display |
|---|---|---|---|
| 100 | Teach-In executing | Before execution | No |
| Other than the execution conditions | Pending | ||
| After execution | Yes - No | ||
| 101 | Normal End | At the normal end | Yes |
| At the abnormal end | No | ||
| 102 | Abnormal End | At the normal end | No |
| At the abnormal end | Yes | ||
| 103 | Timeout error | When a timeout error is not occurred | No |
| When a timeout error is occurred | Yes | ||
| 104 | Abort conditions error | When an error other than the execution conditions is not occurred | No |
| When an error other than the execution conditions is occurred | Yes | ||
| 110 | Execute last Teach-In item | - | The previously conducted scan tool item name is displayed |
| 111 | Internal Error Data | - | The monitoring unit No. is displayed in case of an error |