Diagnostic Procedure

Required Special Tools: 

• MB991958 Scan Tool (M.U.T.-III Sub Assembly)
  • MB991824: Vehicle Communication Interface (V.C.I.)
  • MB991827 M.U.T.-III USB Cable
  • MB991910 M.U.T.-III Main Harness A

1. STEP 1. Scan tool CAN bus diagnostics 

   Using the scan tool, diagnose the CAN bus lines.

   Q: Is the check result normal? 

   1. YES:  Go to Step 2.
   2. NO:  Repair the CAN bus lines. (Refer to TROUBLESHOOTING .)
2. STEP 2. Scan tool diagnostic trouble code 

   Check the AWC diagnostic trouble code. (Refer to DIAGNOSTIC TROUBLE CODE TABLE .)

   Q: Is the DTC set? 

   1. YES:  Perform the relevant troubleshooting.
   2. NO:  Go to Step 3.
3. STEP 3. Check whether the DTC is reset. 

   After 10 or more seconds have passed with the ignition switch ON position, check that the DTC is reset.

   Q: Is DTC No. U0136 set? 

   1. YES:  Replace the mechatronic assembly. (Refer to << A >> MECHATRONIC ASSEMBLY REMOVAL .)
   2. NO:  Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)