LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Rear Axle - Lancer RALLIART, Se) >> On-Vehicle Service >> Wheel Bearing End Play Check

Wheel Bearing End Play Check

WARNING: This page is about a different variant/trim than selected.
  1. Remove the brake caliper assembly and the brake disk. Retain the brake caliper assembly with a wire and the like to prevent from falling (Refer to REAR AXLE HUB ASSEMBLY  and REMOVAL SERVICE POINTS  ).
  2. Set a dial gauge as shown in the illustration. Move the hub in the axial direction and measure the looseness.

    Limit: 0.05 mm (0.002 inch) 

  3. When the looseness exceeds the limit, replace the rear wheel hub assembly (Refer to REAR AXLE HUB ASSEMBLY  and REMOVAL SERVICE POINTS  ).
  4. After checking, install the brake disk and the brake caliper assembly, and tighten the brake caliper mounting bolt to the specified torque (Refer to REAR AXLE HUB ASSEMBLY  and REMOVAL SERVICE POINTS  ).
    Fig 1: Checking Wheel Bearing End Play
    G09626637Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals