LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Rear Axle - Lancer RALLIART, Se) >> Differential Carrier Assembly >> LSD Case Assembly Disassembly And Assembly >> Assembly Service Points >> >> B << Screw Tightening

>> B << Screw Tightening

WARNING: This page is about a different variant/trim than selected.
  1. Align the alignment mark on differential case A with that on differential case B.
  2. Tighten the screws connecting differential case A and B a uniform amount little by little in the diagonal order.
    NOTE: If tightening the screws does not bring the two cases properly together, the spring plates are not probably assembled properly. Reassemble from the start.
    Fig 1: Tightening Differential Case Screws
    G05904455Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals