LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Liftgate - Vehicles With Power Liftgate - With Diagnostics) >> On-Vehicle Service >> Liftgate Alignment >> Adjustment Of Engagement Between Striker And Latch

Adjustment Of Engagement Between Striker And Latch

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear end trim (Refer to INTERIOR TRIMS ).
  2. Replace the striker mounting screws with temporary bolts, and use the remover bar (special tool: MB990939) and a hammer to tap the temporary bolt to the desired direction.
  3. Tighten the striker mounting screws.

    Tightening torque: 22 ± 3 N.m(16 ± 2 ft-lb)

  4. Install the rear end trim (Refer to INTERIOR TRIMS ).
    Fig 1: Installing Rear End Trim
    G09666204Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals