LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Liftgate - Vehicles With Power Liftgate - With Diagnostics) >> On-Vehicle Service >> Check Of Power Liftgate Safety Function

Check Of Power Liftgate Safety Function

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a piece of wood which is approximately 10 mm (0.4 inches) thick at a right angle against the liftgate sensor. Then, by operating the power liftgate switch, liftgate close switch, or keyless operation key power liftgate switch, close the power liftgate.
  2. Check whether the power liftgate opens when the power liftgate clamps the wood chip. If any problem occurs, carry out troubleshooting. Refer to COMMENTS ON TROUBLE SYMPTOM  .
    NOTE: When the safety mechanism is activated successively for two times or more, manually fully close the power liftgate.
scientia non olet · About LEMON Manuals