Liftgate Sensor Check
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
When the load is applied to the pressure detection sensor towards the direction shown in the figure, and when the sensor is pushed approximately 2.2 mm, the liftgate sensor turns ON.
| Sensor position |
Terminal number |
Normal value |
| ON |
1 - 2 |
100 Ω or less |
| OFF |
1 - 2 |
Approximately 1kΩ |
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.