Power Liftgate Control Unit Terminal Inspection

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Power Liftgate Control Unit Connector Terminal

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Terminal number	Terminal code	Check items	Check conditions	Normal conditions
1	BAT1	Battery power supply	Always	Battery voltage
2	GND1	Ground	Always	1 V or less
3	BUP2	Battery power supply	Always	System voltage
4	FULL	Liftgate latch (full latch switch) input	Power liftgate: Overrun position	1 V or less
5	IG12	Ignition switch power supply	Ignition switch: ON	System voltage
6	GOPN	Input from liftgate lock release handle	Liftgate lock release handle: ON	1 V or less
7	CANH	CAN H	-	-
8	CANL	CAN L	-	-
9	GCLS	Input from power liftgate close switch	Power liftgate close switch: ON	1 V or less
10	-	-	-	-
11	PLCL	Liftgate latch (engagement) output	During liftgate latch fully close operation	12 V
12	PLOP	Liftgate latch (release) output	During liftgate latch claw release operation	12 V
13	BZ+	Tone alarm (+) output	Tone alarm is sounding	0 to 12 V (pulse signal)
14	-	-	-	-
15	NTL	Liftgate latch (neutral switch) input	Liftgate latch: Open side (fully open normal status)	1 V or less
16	-	-	-	-
17	HARF	Liftgate latch (half latch switch) input	Power liftgate: Open position	1 V or less
18	-	-	-	-
19	LTH	Liftgate latch (door-ajar switch) input	Power liftgate: Open position	1 V or less
20	-	-	-	-
21	-	-	-	-
22	MASW	Power liftgate main switch input	Power liftgate main switch: ON	1 V or less
23	OPSW	Power liftgate switch input	Power liftgate switch: ON	1 V or less
24	TSL	Liftgate sensor left side input	Liftgate sensor left side: ON	1 V or less
25	TSG	Liftgate sensor ground	Always	1 V or less
26	TSR	Liftgate sensor right side input	Liftgate sensor right side: ON	1 V or less