DTC B2482: No detection of neutral SW: Diagnosis
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Neutral switch inspection.
Check the liftgate latch (refer to LIFTGATE LATCH CHECK ).
Q: Is the check result normal?
- YES: Go to Step 2.
- NO: Replace the liftgate latch.
- STEP 2. Resistance measurement at liftgate latch connector (neutral switch ground line terminal).
- Disconnect the connector, and measure at the wiring harness side.
- Measure the resistance between the liftgate latch connector (neutral switch ground line terminal) and body ground.
OK: Continuity exists (2 Ω or less)
Q: Is the check result normal?
- YES: Go to Step 4.
- NO: Go to Step 3.
- STEP 3. Check of open circuit in ground line between liftgate latch connector (neutral switch terminal) and body ground.
Q: Is the check result normal?
- YES: Go to Step 5.
- NO: Repair the connector(s) or wiring harness.
- STEP 4. Check of open circuit in NTL line between power liftgate control unit connector and liftgate latch connector.
Q: Is the check result normal?
- YES: Go to Step 5.
- NO: Repair the connector(s) or wiring harness.
- STEP 5. Recheck for diagnostic trouble code.
- Clear all the DTC stored in the power liftgate control unit.
- Operate the power liftgate.
- Check whether a DTC is stored in the power liftgate control unit.
Q: Is the DTC stored?
- YES: Replace the power liftgate control unit.
- NO: The diagnosis is complete.