DTC C1900: Tire ID code No. registration: Diagnosis
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.
Use scan tool to diagnose the CAN bus lines.
Q: Is the check result normal?
- YES: Go to Step 2.
- NO: Repair the CAN bus lines (Refer to CAN BUS DIAGNOSTICS TABLE .). On completion, go to Step 2.
- STEP 2. Check whether the DTC is stored again.
Recheck if the DTC is stored.
- Turn the ignition switch (engine starting switch) from the "LOCK" (OFF) to "ON" position.
- Check if the DTC is stored.
- Turn the ignition switch (engine starting switch) to the "LOCK" (OFF) position.
Q: Is DTC C1900 stored?
- YES: Register the ID codes (Refer to TIRE PRESSURE SENSOR ID REGISTRATION .). Then go to Step 3.
- NO: The procedure is complete.
- STEP 3. Check whether the DTC is stored again.
Recheck if the DTC is stored.
- Turn the ignition switch (engine starting switch) from the "LOCK" (OFF) to "ON" position.
- Check if the DTC is stored.
- Turn the ignition switch (engine starting switch) to the "LOCK" (OFF) position.
Q: Is DTC C1900 stored?
- YES: Replace the ETACS-ECU < Vehicles without Keyless Operation System > (Refer to ETACS-ECU .) or KOS-ECU < Vehicles with Keyless Operation System > (Refer to KOS-ECU .), and register the ID codes (Refer to TIRE PRESSURE SENSOR ID REGISTRATION .). Then start over at Step 4.
- NO: The procedure is complete.
- STEP 4. Check whether the DTC is stored again.
- Recheck if the DTC is stored.
- Turn the ignition switch (engine starting switch) from the "LOCK" (OFF) to "ON" position.
- Check if the DTC is stored.
- Turn the ignition switch (engine starting switch) to the "LOCK" (OFF) position.
Q: Is DTC C1900 stored?
- YES: Go to Step 1.
- NO: The procedure is complete.