Inspection Procedure 3: When the CANCEL Switch is Pressed, Cruise Control is not Cancelled: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Check the data list.
CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) ."
2. Turn the ignition switch to the "ON" position.
3. Using M.U.T.-III, check the data list (Refer to DATA LIST REFERENCE TABLE ).
  - Item 75: CANCEL switch
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the check result normal?
1. YES: Go to Step 2.
2. NO: Check the cruise control switch system (Refer to DIAGNOSIS CODE PROCEDURES, CODE NO. P0578: ABNORMAL VOLTAGE AT CRUISE CONTROL SWITCH ). Then go to Step 3.
STEP 2. Check the symptom.
Q: When the CANCEL switch is pressed, is the cruise control cancelled?
1. YES: It can be assumed that this malfunction is intermittent (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
2. NO: Replace the ECM (Refer to ECM < 2.4L ENGINE >, ECM < 3.0L ENGINE >). Then go to Step 3.
STEP 3. Check the symptom.
Q: When the CANCEL switch is pressed, is the cruise control cancelled?
1. YES: The procedure is complete.
2. NO: Return to Step 1.