Inspection Procedure 4: No Diagnostic Trouble Code is stored even when the AWD-ECO/LOCK Indicator Lamps flash: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Check if 4WD/LOCK Indicator Lamps flash simultaneously
1. Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
2. Check that the AWD-ECO/LOCK indicator lamps flash simultaneously when the drive mode selector is switched to 4WD ECO, or 4WD LOCK position.
Q: Does the AWD-ECO/LOCK Indicator Lamps flash simultaneously?
1. YES:
  - When the drive system fluid temperature warning display illuminates in the combination meter, cool down the electronic control coupling.
  - When the drive system fluid temperature warning display does not illuminate in the combination meter, referring to "Inspection Procedure 5: Malfunction of power supply circuit system", perform the check INSPECTION PROCEDURE 1: SCAN TOOL (M.U.T.-III) CANNOT COMMUNICATE WITH THE ELECTRONICALLY CONTROLLER AWD SYSTEM. .
2. NO: Referring to the Inspection Chart for Trouble Symptoms, perform the check TROUBLE SYMPTOM CHART .