LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Electronically Controlled AWD - With Diagnostics) >> Troubleshooting >> Diagnostic Trouble Code Procedures >> Code No. U0100: Engine CAN Timeout >> Diagnosis

Code No. U0100: Engine CAN Timeout: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Scan tool (M.U.T.-III) CAN bus diagnostics. 

    Use scan tool (M.U.T.-III) to perform the CAN bus diagnosis.

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Repair the CAN bus lines (Refer to DIAGNOSIS ). After repairing the CAN bus line, go to Step 2.
  2. STEP 2. Scan tool (M.U.T.-III) other system DTC. 

    Check the engine DTC (Refer to TROUBLESHOOTING < 2.4 L Engine >, TROUBLESHOOTING < 3. 0 L Engine >).

    Q: Is the DTC stored? 

    1. YES:  Perform the relevant troubleshooting.
    2. NO:  Go to Step 3.
  3. STEP 3. Check whether the DTC is stored again. 

    Q: Is DTC No. U0100 stored? 

    1. YES:  Replace the AWD-ECU (Refer to AWD-ECU  ). Then go to Step 4.
    2. NO:  Intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
  4. STEP 4. Check whether the DTC is stored again. 

    Q: Is DTC No. U0100 stored? 

    1. YES:  Return to  Step 1.
    2. NO:  This diagnosis is complete.
scientia non olet · About LEMON Manuals