LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle On-Vehicle Service - With Diagnostics) >> Automatic Transaxle Diagnosis < A/T > >> Diagnostic Trouble Code Procedures >> Inspection Procedure 3: The vehicle does not run at the "D" or the "R" range >> Diagnosis

Inspection Procedure 3: The vehicle does not run at the "D" or the "R" range: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Check the transaxle control cable. 

    Check the installation status of transaxle control cable and transmission range switch.

    Q: Is the check result normal? 

    • YES:  Go to Step 2.
    • NO:  Adjust the installation status of transaxle control cable and transmission range switch. (Refer to TRANSMISSION RANGE SWITCH CHECK  .)
  2. STEP 2. Check the transmission fluid. 

    Check the transmission fluid for seizure, fouling, and level.

    Q: Is the check result normal? 

    • YES:  The procedure is complete.
    • NO:  Go to Step 3.
  3. STEP 3. Remove the transaxle assembly from the vehicle. 

    Disassemble and check the transaxle assembly to check if there is a foreign material inside.

    Q: Is the check result satisfactory? 

    • YES:  Replace the transaxle assembly.
    • NO:  Replace the failure part.
scientia non olet · About LEMON Manuals