Diagnostic Procedure

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Scan tool (M.U.T.-III) CAN bus diagnostics.
Use scan tool (M.U.T.-III) to perform the CAN bus diagnosis.

Q: Is the check result normal?
1. YES: Go to Step 3.
2. NO: Repair the CAN bus lines (Refer to CAN BUS DIAGNOSTICS TABLE ). After repairing the CAN bus line, go to Step 2.
STEP 2. Check whether the DTC is stored again.
Q: Is DTC No. C1615 stored?
1. YES: Go to Step 3.
2. NO: This diagnosis is complete.
STEP 3. Scan tool (M.U.T.-III) other system DTC.
Check the ASC DTC (Refer to DIAGNOSTIC TROUBLE CODE CHART ).

Q: Is the DTC stored?
1. YES: Perform the relevant troubleshooting.
2. NO: Go to Step 4.
STEP 4. Scan tool (M.U.T.-III) DTC.
Check other AWC diagnostic trouble code. (Refer to DIAGNOSTIC TROUBLE CODE CHART )

Q: Is the DTC stored?
1. YES: Perform the relevant troubleshooting.
2. NO: Go to Step 5.
STEP 5. Check whether the DTC is stored again.
Q: Is DTC No. C1615 stored?
1. YES: Replace the AWC-ECU (Refer to AWC-ECU < Vehicles with S-AWC > ).
2. NO: Intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).