LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Continuously Variable Transaxle (CVT) On-Vehicle Service - With Diagnostics) >> Diagnosis < S-AWC > >> Diagnostic Function >> Fail-safe function

Fail-safe function

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

If the AWC-ECU receives an abnormal signal from sensors, switches, or solenoids, it will enter a fail-safe mode to ensure the safety of the driver and prevent damage to the system.

FAIL-SAFE REFERENCE DESCIPTION

DTC No. Control content
C1613, C1614 The multi-information display should inform the driver of a system malfunction, but the vehicle handling will not be affected. The electronic controlled S-AWC will continue to work.
C1219, C121A, C123C, C1242, C1623, C1630, C1632, C1633, C1634, C2205, U0100, U0101, U0126, U0131, U0401, U0428, U1425, U1426, U1428, U142B The multi-information display should inform the driver of a system malfunction, and the system control will be disabled partially.
C161F, C1621 "4WD SYSTEM OVERHEATING" will be displayed on the multi-information display, and the system will protect the drive train components.
C100A, C1011, C1014, C1015, C101C, C101F, C1020, C1027, C102A, C102B, C1032, C1035, C1078, C1610, C1615, C1616, C1624, C1626, C1627, C1628, C1629, C1631, C1635, C1707, C2100, C2101, U0121, U0141, U0431, U1073, U1195, U1427 The multi-information display should inform the driver of a system malfunction, and the system will be disabled.
NOTE: When the ignition switch is turned from OFF to ON, all of the fail-safe controls will be resumed.
scientia non olet · About LEMON Manuals